Therefore, we recommend replacing it with a cable showing the correct 2C code. Note: If your USB cable is not labeled with the 2C code, it may or may not be suitable for use with our hardware devices. 28/2C, 28AWGX2C, AWG 28X2C), it is not suitable for use with our hardware devices. If your cable is showing a / 2C (or X2C) code beginning with 28 (e.g. Look for the molded NI logo on the plugs to identify these cables. The NI-branded cables supplied with our products do not carry any of the AWG codes, however, they are specified with the larger AWG 24 diameter to ensure the best performance with your Native Instruments device. As described above, this means the power wires have a diameter of 0,511 mm, which will reduce the power lost in the cable. Our tests have shown that you should always use USB cables carrying a / 2C (or X2C) code beginning with 24 (e.g. The number at the beginning of the codes reflects the diameter of the internal wires:
#Best traktor controller cable code
The code ending with /1P (or X1P) shows the specification of the data wires in the USB cable.The code ending with /2C (or X2C) shows the specification of the power wires in the USB cable (relevant for this test).Most USB cables are labeled with the two identification codes following the AWG (American Wire Gauge) standard: Note: These specifications also apply to USB-B to USB-C cables which can be used on newer systems equipped with USB-C or Thunderbolt 3 ports.
#Best traktor controller cable how to
Below you can find information on how to identify the correct cable type. This draws additional power along the cable, exceeding the capacity of USB bus-powered mode. Type of CableĬertain USB cable types are not suitable for use with our hardware devices due to the diameter of their internal power wires being too small. KOMPLETE KONTROL S-Series Keyboards, MASCHINE Studio, etc.) the USB cable can be longer without causing any issues. If your device has a dedicated power supply (e.g. KOMPLETE AUDIO 6, MASCHINE MK2, etc.) we recommend using cables with a maximum length of 2 meters (approximately 6.5 feet). Cable Lengthįor devices that don't offer a dedicated power supply (e.g. Note: We strongly recommend using the USB cable provided with the hardware product you have purchased, as opposed to a third-party USB cable. Inadequate USB cables can cause a variety of issues, including: This article provides useful information on choosing the correct USB cable for connection between your system and your Native Instruments device.
0 kommentar(er)
